The Two Phase Second Rocker (Heel to Ball of Foot) described in the previous post is dependent on inertia impulse loading. A good discussion of the basics of inertia and momentum is found in Inertia, Momentum, Impulse and Kinetic Energy (1.)
Limitations of Pressure Insoles used in Skiing
A paper published on May 4, 2017 called Pressure Influence of slope steepness, foot position and turn phase on plantar pressure distribution during giant slalom alpine ski racing by Falda-Buscaiot T, Hintzy F, Rougier P, Lacouture P, Coulmy N. while noting that:
Pressure insoles are a useful measurement system to assess kinetic parameters during posture, gait or dynamic activities in field situations, since they have a minimal influence on the subject’s skill.
acknowledge limitations in pressure insoles:
However, several limitations should be pointed out. The compressive force is underestimated from 21% to 54% compared to a force platform, and this underestimation varies depending on the phase of the turn, the skier’s skill level, the pitch of the slope and the skiing mode.
It has been stated this underestimation originates from a significant part of the force actually being transferred through the ski boot’s cuff. As a result, the CoP trajectory also tends to be underestimated along both the anterior-posterior (A-P) and medial-lateral (M-L) axes compared to force platforms.
Forces transferred through the cuff of a ski boot to the ski can limit or even prevent the inertia impulse loading associated with the Two Phase Second Rocker/Turntable Effect. In addition, forces transferred through the cuff of a ski boot to the ski intercept forces that would otherwise be transferred to a supportive footbed or orthotic.
Rocker Roll Over
In his comment to my post, OUTSIDE SKI BALANCE BASICS: STEP-BY-STEP, Robert Colborne said:
In the absence of this internal rotation movement, the center of pressure remains somewhere in the middle of the forefoot, which is some distance from the medial edge of the ski, where it is needed.
Rock n’ Roll
To show how the Two Phase Second Rocker rocks and then rolls the inside ski onto its inside edge at ski flat during edge change, I constructed a simple simulator. The simulator is hinged so as to tip inward when the Two Phase Second Rocker shifts the center of pressure (COP) from under the heel, on the proximate center of a ski, diagonally, to the ball of the foot.
The red ball in the photo below indicates the center of gravity (COG) of the subject. When COP shifts from the proximate center to the inside edge aspect, the platform will tilt and the point of COP will drop with the COG in an over-center mechanism.
A sideways (medial) translation of the structures of the foot away from the COG will also occur as shown in the graphic below. The black lines indicate the COP center configuration of the foot. The medial translation of the foot imparts rotational inertia on the platform under the foot.
Two Phase Second Rocker: The Movie
The video below shows the Two Phase Second Rocker.
Click on the X on the right side of the lower menu bar of the video to enter full screen.
The graphic below shows to Dual Plane Turntable Effect that initiates whole leg rotation from the pelvis applying multi-plane torque to the ski platform cantilevering reaction force acting along the running edge of the outside ski out under the body of the ski. A combination of over-center mechanics and internal (medial or into the turn) application of rotation of the leg from the pelvis, counters torques resulting from external forces.